Description:
BELT I (35)
ACDelco Specialty Premium Industrial Molded Notched Belts are best suited for use on special drives where space, weight, and horsepower capacity are critical. These narrow cross-sections can transmit up to three times the horsepower of the classical cross-sections (A, B, C, and D) in the same amount of drive space. ACDelco Specialty Premium Industrial Molded Notched Belts provide proper cord support and full contact with the sheave-groove for uniform loading, uniform wear, and increased belt life. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Has flex-bonded cords that are strongly bonded to the body of the belt resulting in equal load distribution and the absorption of bending stress without cord deterioration
- Meets or exceeds RMA standards for static conductivity and heat and oil resistance
- Provides proper cord support and full contact with the sheave-groove for uniform loading, uniform wear, and increased belt life
- The belt's cover is a patented construction for longer cover life, providing extended protection to the core of the belt from oil, dirt, and heat
Specifications:
Cross Section Designation:
3VX450
Outside Circumference:
1143 mm
Outside Circumference:
45.00 in.
Features and Benefits:
- – Check for proper belt tension after 500 to 1,000 miles following belt installation. Recheck often, at least twice a year or every 6,000 miles.
- – Do not use belt dressings to stop belt slippage or noise. These are oil based and may cause belt deterioration.
- – Never twist a belt more than 90 degrees during inspection. This may damage the tensile cords and cause premature failure.
- – Replace V-belts after 3 to 4 years, or every 36,000 to 48,000 miles.
- – Use an approved tension gauge to check belt tension.
Specifications:
