ACDelco 03754587 Engine Water Pump Gasket
for 1992 (please select make/model)

ACDelco 03754587 Engine Water Pump Gasket - 1992


Brand:	ACDelco
Part Number:	03754587
UPC:	00021625676791
Weight:	0.2 lbs
Condition:	New

On Sale:

$54.36

Availability:

3 in Stock

Warehouse:

US-4

Quantity:

Product Information

Description:

Get the ACDelco 03754587 Engine Water Pump Gasket for your 1992. Buy now and secure your purchase online!

GM Genuine Parts Engine Water Pump Gaskets are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These gaskets are used between the water pump housing and the engine block or another component to seal the interface between the components. The gasket may be made of fiber or a rubberized composite material that provides a liquid-tight connection. The gasket helps keep the engine coolant in and keeps air out. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE). ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov

Features and Benefits:

GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
GM regularly updates production and service part designs to integrate new materials and technologies
May be made from fiber or a rubberized composite material
Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)

Specifications:

Center Bore Diameter (mm):

27.76mm

Height (in):

4.62 in

Length (in):

3.9 in

Material:

Armstrong Syntheseal

Mount Hole Quantity:

Programming Required:

Thickness:

0.033 mm

Thickness:

0.86 in.

Weight (lb):

0.2 lb

Width (in):

5.02 in

Features and Benefits:

– A stain around the weep hole is acceptable. However, if a weep occurs with the engine running and the coolant system pressurized, then the water pump should be replaced.
– After installation, pressure-test the system for leaks and check for sufficient fan blade clearance between the blade and radiator shroud.
– Clean all excess dirt and debris from the water pump housing.
– Clean all sealing surfaces, and make sure all old gasket material is removed before installing your replacement component.
– Clean and reinstall the coolant recovery reservoir before flushing the cooling system.
– Do not use any non-approved flush agents and replace the coolant according to manufacturer's specifications.
– Flush the cooling system completely, using power flush equipment or thermal cycling the system with clean water three times. The most effective method of system flushing is to use a coolant exchanger, following the manufacturer's operating instructions.
– Inspect for leakage at the water pump outlet housing or the rear cover gasket, and leakage at the water pump vent or weep hole.
– Inspect related components in the cooling system, including your fan blades, fan clutch, engine mounts, radiator, belts and hoses, and reservoir.
– Never strike the water pump shaft, since this will damage the new water pump.
– Run your vehicle to increase engine temperature, and ensure the system is pressurized.
– Torque all bolts according to the manufacturer's specifications and adjust belts to proper tension (if applicable) to manufacturer's specifications.
– Use sealant tabs only if recommended. Some sealant tabs or similar compounds may restrict coolant flow through the passages of some cooling systems.
– With the new pump installed, turn the hub by hand and check for rotation.
Before purchasing and installing an engine water pump gasket, make sure it is the correct fit for your vehicle.
Tips for Water Pump Inspection:
Tips for Water Pump Servicing & Installation:

Specifications:

Country of Origin: