Description:
BELTINDUSTRIAL EQUIPMENT
ACDelco Professional, premium aftermarket Industrial Notched Belts are constructed with proprietary construction giving them a superior combination of flex and load carrying capacity, as well as less stretch resulting in less maintenance. These belts provide superior performance on the toughest heavy duty A, B, and C Section industrial drives and is suitable for all industrial applications, particularly where small or sub-minimal sheave diameters are required. These premium aftermarket replacement industrial notched belts are manufactured to meet your expectations for fit, form, and function. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Belts that are longer than 210 inches are a banded, cut notch construction for customer convenience
- Has flex-bonded cords that are strongly bonded to the body of the belt resulting in equal load distribution and the absorption of bending stress without cord deterioration
- Has notches that are molded into the belt during manufacturing that make this belt well suited for drives with smaller diameter sheaves
- Its edge is machined for even sheave-groove contact resulting in less slip and wear
- Meets RMA oil and heat resistant standards and RMA static conductivity requirements for increased belt life
Specifications:
Cross Section Designation:
BX46
Outside Circumference:
1245 mm
Outside Circumference:
49.00 in.
Features and Benefits:
- – Check for proper belt tension after 500 to 1,000 miles following belt installation. Recheck often, at least twice a year or every 6,000 miles.
- – Do not use belt dressings to stop belt slippage or noise. These are oil based and may cause belt deterioration.
- – Never twist a belt more than 90 degrees during inspection. This may damage the tensile cords and cause premature failure.
- – Replace V-belts after 3 to 4 years, or every 36,000 to 48,000 miles.
- – Use an approved tension gauge to check belt tension.
Specifications:
