Description:
ACDelco GM Original Equipment Rack and Pinion Assemblies convert the rotation of your vehicle's steering column to the side-to-side motion needed to steer its front or rear wheels, and are GM-recommended replacements for your vehicle's original components. These original equipment rack and pinion assemblies have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Converts steering column rotation into side-to-side motion needed to steer wheels
- GM-recommended replacement part for your GM vehicle's original factory component
- Manufactured to GM OE specification for fit, form, and function
- Offering the quality, reliability, and durability of GM OE
Specifications:
End To End Length:
1112.91 mm
End To End Length:
43.82 in.
Gasket Or Seal Included:
No
Inner Tie Rods Included:
Yes
Mounting Hardware Included:
No
Mounting Hole Quantity:
2
Outer Tie Rods Included:
Yes
Steering Input Shaft Diameter:
0.66 in.
Steering Input Shaft Diameter:
16.80 mm
Features and Benefits:
- – A shimmy or shake in the steering wheel
- – Especially have the inner and outer tie rods inspected for grease leaks and excessive lash or 'play'
- – Heavy or unresponsive steering at low speeds or during parking lot maneuvers
- – Service power steering system light illuminating in the driver information center
- – Steering wheel not returning to 'center' properly
- – Unusual noise when turning the steering wheel
- – Wet spots/fluid stains on the ground beneath the vehicle
- For hydraulic power steering systems:
- Have your vehicle inspected if it exhibits any of the following symptoms:
- If you live in areas that experience harsh winter weather, have the entire steering system inspected before winter arrives.
Specifications:
