Description:
ACDelco GM Original Equipment Brake Hydraulic Hoses are quality reinforced hoses that carry fluid to transmit force within the brake system, and are GM-recommended replacements for your vehicle's original components. Brake lines and hoses are designed to withstand high pressures, and these brake hydraulic hoses have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- GM-recommended replacement part for your GM vehicle's original factory component
- Manufactured with GM Original Equipment specification for fit, form, and function
- Offering the quality, reliability, and durability of GM OE
Specifications:
End 1 Fitting Material:
Steel
End 1 Fitting Type:
Banjo
End 1 Inside Diameter (in):
0.4 in
End 1 Inside Diameter (mm):
10.15 mm
End 2 Fitting Material:
Steel
End 2 Fitting Type:
Flare
End 2 Inside Diameter (in):
0.41 in
End 2 Inside Diameter (mm):
10.44 mm
End 2 Thread Diameter (in):
0.39 in
End 2 Thread Diameter (mm):
10 mm
Gasket Or Seal Included:
Yes
Mounting Hardware Included:
Yes
Outer Sleeve Material:
Rubber
Volume (cu in):
155.92cu in
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems.
- The following should be conducted by a qualified technician:
Specifications:
