Description:
ROTOR RR BRK (SLP)
ACDelco GM Original Equipment Disc Brake Rotors are metal discs mounted to the wheel hub where the caliper can press the brake pads against the disc surfaces to slow the vehicle, and are GM-recommended replacements for your vehicle's original components. These disc brake rotors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- GM-recommended replacement part for your GM vehicle's original factory component
- Inspected for balance, resulting in smooth brake operation and noise reduction
- Manufactured to GM OE specification for fit, form, and function
- Offering the quality, reliability, and durability of GM OE
Specifications:
Bolt Circle Diameter (in):
4.33 in
Bolt Circle Diameter (mm):
110 mm
Center Hole Diameter:
65.53 mm
Disc Brake Rotor Construction:
Solid
Discard Thickness:
0.314 in.
Includes ABS Sensor Ring:
No
Max Bolt Hole Diameter (mm):
14mm
Max Center Hole Diameter (mm):
65.6mm
Nominal Thickness:
0.393 in.
Outside Diameter:
11.26 in.
Overall Rotor Diameter (mm):
286mm
Pitch Circle Diameter (mm):
110mm
Rust Resistant Coating:
Yes
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems.
- The following should be conducted by a qualified technician:
Specifications:
