Description:
ACDelco Specialty Performance (Fleet/Police) Remanufactured Loaded Disc Brake Calipers use both aluminum and iron castings for the best match to the original equipment design. Remanufacturing disc brake calipers is an automotive industry practice that involves disassembly of existing units, and replacing components that are most prone to wear with new components. Damaged and obsolete parts are replaced and are end of line tested to ensure they perform to ACDelco specifications. In addition, remanufacturing returns components back into service rather than processing as scrap or simply disposing of them. These loaded calipers contain high temperature silicone components to provide superior resistance to heat, withstanding temperatures up to 600 degrees Fahrenheit (316 degrees Celsius), while protecting against corrosion and leakage. ACDelco Specialty Performance (Fleet/Police) Remanufactured Loaded Disc Brake Calipers are developed with brake pads already attached - no assembly required. Also included are bleeder screws, copper sealing washers, hardware, and mounting brackets for easy installation. These disc brake calipers will provide the same performance, durability, and service life you expect from ACDelco. WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Noise damping shims included for quiet braking
- Police-specific formulations to avoid high temperature fade
- Pre-lubed and loaded with quality friction pads for smooth operation
- Slotted and chamfered to optimize cooling and reduce noise
- The following inspections and maintenance procedures can help prevent potential brake problems:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- The following should be conducted by a qualified technician:
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
Specifications:
ACD_RemanDesc_woNo:
Remanufactured
ACD_Reman_Sentence:
Remanufactured - Not for sale where imports are restricted. Centigrade, Celsius
Bleeder Thread Diameter:
M10x1
Caliper Slides Included:
YES
Casting Material:
Cast Iron
Comparison Chart 1:
PL14_CC_SpecBrakes_Calipers.jpg
Friction Material Composition:
Metallic
Inlet Fitting Type:
Female
Inlet Thread Diameter:
0.375 in.
Product Type:
Fleet, Loaded with Semi-Metallic Pads
Mounting Bracket Included:
Yes
Mounting Hardware Included:
Yes
Mounting Hole Diameter:
14 in.
New Or Remanufactured:
Remanufactured
Pad Wear Sensor Included:
NO
Piston 1 Diameter:
2.0 in.
Piston 2 Diameter:
2.0 in.
Manufacturer Warranty:
12 Months/Unlimited Miles Warranty (Parts Only). Please see ACDelco.com for more details
