Description:
CYLINDER (B)
ACDelco Professional Drum Brake Wheel Cylinders use both aluminum and iron castings making them a high quality replacement for many vehicles on the road today. These wheel cylinders contain both Ethylene Propylene (EPDM) and Styrene Butadiene (SBR) rubber components to provide superior resistance to heat, corrosion, and leakage. Formulated with a smooth bore finish, these cylinders have a quality seal to help increase the life of rubber components. ACDelco Professional Drum Brake Wheel Cylinders are ready to bench bleed and install right out of the box - no assembly required. These premium aftermarket replacement drum brake wheel cylinders are manufactured to meet your expectations for fit, form, and function. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Cast iron and aluminum specifications; no extra stress on the brake boosting mounting
- Meets the brake performance requirements of SAE J1153 and J1154 testing, providing reliability and quality
- Pressure tested to ensure safe and confident braking
- Trivalent coated bleeder screws provide extra protection and added durability
Specifications:
Bleeder Screw Cap Included:
Yes
Bleeder Screw Included:
Yes
Bore Diameter:
0.8125 in.
Bore Diameter:
20.6375 mm
Brake Line Inlet Thread Diameter:
0.437 in.
Brake Line Inlet Thread Diameter:
11.1 mm
Casting Material:
Cast Iron
Cylinder Bore Diameter:
0.594 in.
Measurements:
9 or 10 in (7/16 X 24 in Offset Inlet, 5/16 X 18 in Thread Mounting Hole
Mounting Hardware Included:
No
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems:
- The following should be conducted by a qualified technician:
Specifications:
