Description:
ACDelco Professional Disc Brake Rotors provide reliable vehicle braking power and are a high quality replacement for many vehicles on the road today. They feature a thickness variation that is less than 0.0004 to minimize pedal pulsation, noise, and help to extend brake pad life. These rotors meet the SAE standard for structural integrity with OE matched G3000 qualified material delivering guaranteed performance. Also, no machining is required. ACDelco Advantage Disc Brake Rotors are ready to be installed right out of the box. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Follows original manufacturers' designs for dispersing heat, helping to prolong pad and rotor life while reducing noise and vibration
- Independently tested with Noise/Vibration/Harshness (NVH) and durability/wear testing; resulting in high quality and reliable products
- Inspected for balance; resulting in smooth brake operation and noise reduction
Specifications:
ABS Tone Ring Included:
No
Bolt Circle Diameter (in):
4.5 in
Bolt Circle Diameter (mm):
114.3 mm
Center Bore Diameter (in):
2.5in
Center Bore Diameter (mm):
64.1mm
Center Hole Diameter:
2.524 in.
Center Hole Diameter:
64.1 mm
Conventional Or Drum-In-Hat Type Rotor:
Drum-In-Hat
Discard Thickness:
0.315 in.
Inside Diameter:
208.8 mm
Inside Diameter:
8.22 in.
Mounting Bolt Hole Circle Diameter:
114.3 mm
Mounting Bolt Hole Circle Diameter:
4.5 in.
Mounting Bolt Hole Diameter:
114.3 mm
Mounting Bolt Hole Diameter:
4.5 in.
Mounting Bolt Hole Quantity:
5
Nominal Thickness:
0.354 in.
Outside Diameter:
12.008 in.
Overall Height:
2.252 in.
Overall Rotor Diameter (mm):
305.05mm
Pad Contact Surface Width:
1.7 in.
Pad Contact Surface Width:
43.1 mm
Rust Resistant Coating:
No
Solid Or Vented Type Rotor:
Solid
Stud/Lug Hole Quantity:
5
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems:
- The following should be conducted by a qualified technician:
Specifications: