Description:
ACDelco Gold (Professional) Disc Brake Rotors are a high quality alternative to Original Equipment (OE) parts. They feature a thickness variation that is less than 0.0004 to minimize pedal pulsation, noise, and help to extend brake pad life. These rotors meet the SAE standard for structural integrity with OE matched G3000 qualified material delivering guaranteed performance. Also, no machining is required. ACDelco Gold (Professional) Disc Brake Rotors are ready to be installed right out of the box. ACDelco Gold (Professional) parts are manufactured to meet your expectations for fit, form, and function, making them a smart choice for General Motors vehicles, as well as most makes and models, including special applications. These high-quality parts are backed by General Motors. Some ACDelco Gold parts may have formerly appeared as ACDelco Professional. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Follows original manufacturers' designs for dispersing heat, helping to prolong pad and rotor life while reducing noise and vibration
- Independently tested with Noise/Vibration/Harshness (NVH) and durability/wear testing; resulting in high quality and reliable products
- Inspected for balance; resulting in smooth brake operation and noise reduction
- Manufactured to meet specifications for fit, form, and function for General Motors vehicles as well as most makes and models
- Premium aftermarket replacement part
- Some ACDelco Gold parts may have formerly appeared as ACDelco Professional
Specifications:
ABS Tone Ring Included:
No
Bolt Circle Diameter (in):
5.7 in
Bolt Circle Diameter (mm):
145 mm
Center Bore Diameter (in):
4.9in
Center Bore Diameter (mm):
123.3mm
Center Hole Diameter:
123.3 mm
Center Hole Diameter:
4.854 in.
Conventional Or Drum-In-Hat Type Rotor:
Drum-In-Hat
Discard Thickness:
1.591 in.
Discard Thickness:
40.4 mm
Inside Diameter:
9.803 in.
Mounting Bolt Hole Circle Diameter:
145 mm
Mounting Bolt Hole Circle Diameter:
5.709 in.
Mounting Bolt Hole Diameter:
0.507 in.
Mounting Bolt Hole Diameter:
12.9 mm
Mounting Bolt Hole Quantity:
8
Nominal Thickness:
1.654 in.
Outside Diameter:
13.583 in.
Overall Height:
166.65 mm
Overall Height:
6.561 in.
Overall Rotor Diameter (mm):
344.93mm
Pad Contact Surface Width:
1.9 in.
Pad Contact Surface Width:
48 mm
Rust Resistant Coating:
No
Solid Or Vented Type Rotor:
Vented
Stud/Lug Hole Quantity:
8
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems:
- The following should be conducted by a qualified technician:
Specifications:
