Description:
ACDelco Specialty Performance (Fleet/Police) Semi-Metallic Disc Brake Pads are formulated with steel strands to provide strength and conduct heat away from the rotor's surface while offering premium braking power. They are engineered to help resist corrosion and premature wear. They offer exceptional performance and include noise-dampening shims where applicable. These brake pads are specifically designed to meet the demands of police and fleet vehicles. ACDelco Specialty Performance (Fleet/Police) Semi-Metallic Brake Pads are ready to be installed right out of the box - no curing required. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- Ceramic, semi-metallic, and organic formulas provide safety and reliability for a range of vehicle applications
- Friction material is integrally molded to backing plate for bond integrity
- Nucap Retention System (NRS) backing plates used when possible for superior performance
- Premium chamfers and slots match up with original equipment
- Rubberized adjustment clips for quiet operation
- Tested to SAE J2784 standards for braking effectiveness, along with Noise/Vibration/Harshness (NVH) and durability/wear testing for assurance of quality
- Utilize damped iron metallurgy to reduce noise, vibration, and heat
Specifications:
Friction Material Attachment:
Bonded
Friction Material Composition:
Metallic
Inner Pad Friction Material Thickness:
0.71 in.
Inner Pad Friction Material Thickness:
18 mm
Inner Pad Height:
2.530 in.
Inner Pad Overall Thickness:
0.710 in.
Inner Pad Width:
7.250 in.
Mounting Hardware Included:
Yes
Outer Pad Friction Material Thickness:
0.71 in.
Outer Pad Friction Material Thickness:
18 mm
Outer Pad Height:
2.530 in.
Outer Pad Overall Thickness:
0.710 in.
Outer Pad Width:
7.250 in.
Pad Wear Sensor Included:
No
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems:
- The following should be conducted by a qualified technician:
Specifications:
