Description:
The ACDelco GM Original Equipment Disc Brake Caliper Repair Kit contains GM-recommended replacements for your vehicle's original components. This brake caliper repair kit includes the necessary bolts, fasteners, bushings, and other hardware needed to repair your vehicle's disc brake caliper, which have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- GM-recommended replacement part for your GM vehicle's original factory component
- Manufactured with GM Original Equipment specification for fit, form, and function
- Offering the quality, reliability, and durability of GM OE
Specifications:
Caliper Grease Included:
No
Package Includes:
Piston Seal, Piston Boot, Inner Pad Retainer Spring
Piston Boot Inside Diameter:
1.8 in.
Piston Boot Inside Diameter:
44.6 mm
Piston Boot Material Thickness:
0.3 in.
Piston Boot Material Thickness:
7.4 mm
Piston Boot Material:
Rubber
Piston Boot Outside Diameter:
3.1 in.
Piston Boot Outside Diameter:
78.2 mm
Piston Seal End 1 Outside Diameter:
2.76 in.
Piston Seal End 1 Outside Diameter:
70.06 mm
Piston Seal Material:
Rubber
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems.
- The following should be conducted by a qualified technician:
Specifications:
