Description:
GM Genuine Parts Disc Brake Pads are designed, engineered, and tested to rigorous standards, and are backed by General Motors. Disc Brake Pads are the friction material used in disc brakes that press against the brake rotor to stop the vehicle. This friction-enhancing material is bonded and/or riveted to steel backing plates. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE). ⚠ WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov
Features and Benefits:
- GM Engineers design and validate OE parts specifically for your Chevrolet, Buick, GMC, or Cadillac vehicle
- GM Genuine Parts are designed, engineered and tested to rigorous standards, and are backed by General Motors
- GM regularly updates production and service part designs to integrate new materials and technologies
- Integrally molded - friction material molded to backing plate for bond integrity
- Premium shims, slots, and chamfers help to diminish noise, vibration, and braking harshness
- Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE)
Specifications:
Abutment Clips Included:
Yes
Friction Material Attachment:
Bonded
Inner Pad Friction Material Thickness:
0.485 in.
Inner Pad Friction Material Thickness:
12.33 mm
Mounting Hardware Included:
Yes
Original Equipment Replacement:
Yes
Outer Pad Friction Material Thickness:
0.485 in.
Outer Pad Friction Material Thickness:
12.33 mm
Pad Wear Sensor Included:
Yes
Pad Wear Sensor Type:
Mechanical
Features and Benefits:
- – Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
- – Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
- – Check the thickness of your brake pads.
- – Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
- – Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
- – Inspection of the brake hoses for brittleness or cracking.
- – Inspection of wheel bearings and grease seals.
- – Parking brake adjustments (as needed).
- The following inspections and maintenance procedures can help prevent potential brake problems.
- The following should be conducted by a qualified technician:
Specifications:
