Description:
CARDONE Remanufactured Hydraulic Power Brake Boosters are re-engineered, built and tested to match O.E. performance. Original designs are scrutinized for potential improvement and, where applicable, design upgrades are implemented to produce a more durable part than the original. All units are 100% tested to ensure perfect fit and function.
Features and Benefits:
- 100% O.E. quality seals are installed on every unit for like-new performance and reliability.
- 100% O.E. quality seals, and check valves are installed on every unit for like-new performance and reliability.
- All units are 100% tested to ensure reliable performance.
- Exclusive rust-prohibitive finishing process extends unit life.
- Guaranteed fit and function.
- Master cylinder output rods are pre-adjusted (when included) for quick and easy installation.
- Protective coating prevents corrosion and extends product life.
- Remanufactured to match O.E. performance.
Specifications:
Brake Pedal Rod Extension Included:
No
Brake Service Grade:
Regular
Contains Electronic Components:
No
FAA_A1:
Hydraulic boosters are most commonly used on heavy duty pickup trucks and industrial applications. However, hydraulic boosters can be found on passenger vehicles as well.
FAA_A2:
As part of the power steering system, hydraulic boosters require O.E. power steering fluid.
FAA_A3:
Yes, the master cylinder pushrod, spring and retainer will need to be retained and reused on the replacement hydraulic booster.
FAA_A4:
The hydraulic booster is designed to operate within the pressure range of the power steering system. In most cases this is at least 1200 PSI (deadhead pressure).
FAA_A5:
Yes, since the power steering lines have been removed, the system has been subjected to air. The power steering system will need to be bled using the O.E. bleeding procedure.
FAA_A6:
Most hydraulic boosters are equipped with a pedal rod identification number. These numbers are stamped on the end of the pedal rod near the eyelet. The pedal rod identification number is one of the most accurate ways to choose the correct replacement hydraulic booster.
FAA_A7:
A hydraulic booster can be tested just like a vacuum booster. With the engine off, pump the brake pedal until you feel firm resistance, then hold. Start the engine. Proper operation should result in the brake pedal slightly sinking.
FAA_A8:
Yes, the hydraulic booster should be flushed along with the power steering system. This should be done in accordance with the O.E. maintanence intervals.
FAA_A9:
This is possible, but not recommended. Altering or modifying a brake system puts the vehicle at higher risk of brake failure.
Gasket Or Seal Included:
Yes
Housing Diameter:
2.339 in.
Housing Diameter:
59.41 mm
Housing Material:
Cast Iron
Is Or Contains A Battery:
No
Is Or Contains A Bulb:
No
Is Prop Sixty Five Affected:
No
Is the item CARB affected:
No
Master Cylinder Included:
No
Master Cylinder Stud Thread Size:
10x1.5
Mounting Bracket Included:
Yes
Mounting Hardware Included:
No
Package Contents:
Hydro Boost; Instruction Sheet; Sealing Kit
Product Condition:
Remanufactured
General Motors #:
22745516
Manufacturer Warranty:
12 Months
