Description:
Power steering pulleys are an important component in the drive system for belt-driven steering pumps and should be replaced during any power steering pump service. CARDONE New Power Steering Pulleys are manufactured using the most stringent quality processes to deliver smooth, consistent performance in any driving condition. As a direct-fit component, each pulley installs easily, saving precious labor time while providing peace of mind. In an industry where time is such a valuable commodity, CARDONE strives to help make sure your time is spent wisely.
Features and Benefits:
- Direct replacement of original pulley
- Direct replacement of original pulley.
- Pulley front fascia designed with O.E. cutouts for ease of pump removal or installation, where applicable.
- Same grade material and gauge as O.E. for strength and durability
- Same grade material and gauge as O.E. for strength and durability.
- Simple installation with correct tools.
- Tested to meet same performance as O.E.
Specifications:
Contains Electronic Components:
No
FAA_A1:
The age and continual flexing of a belt will cause it to crack and deteriorate. Stretching loosens the belt, causing it to slip on the pulleys. A cracked belt will eventually break. The tension and general condition of the belt should be checked periodically.
FAA_A2:
Yes, use of the correct tool based on engine application and pulley type is necessary to prevent damage to the pulley.
FAA_A3:
Pulleys are painted with weather resistant epoxy paint.
FAA_A4:
The replacement pulley should be pressed to the point where the hub is flush with the end of the shaft.
FAA_A5:
Accessory pulley alignment should be checked using a straightedge if a pulley alignment issue is suspected. The straightedge should lie flat across the fascia of two adjacent pulleys. If the straightedge does not lie flat, then one of the pulleys is misaligned. To validate which of the pulleys is causing the issue, check each against other pulleys until you isolate the one that is out of line. Pulley alignment can also be checked with a laser alignment tool.
FAA_A6:
Pulleys are typically made of plastic composite nylon or steel.
FAA_A7:
Flat, V-belt, and Multi groove.
Is Or Contains A Battery:
No
Is Or Contains A Bulb:
No
Is Prop Sixty Five Affected:
No
Is the item CARB affected:
No
Mounting Hardware Included:
No
Mounting Hole Quantity:
3
Outside Diameter:
132.72 mm
Outside Diameter:
5.225 in.
Shaft Diameter:
1.142 in.
